Vacu-Boom™ For Pressure Washers

Vacu-Boom™ For Pressure WashersThe Vacu-Boom system is engineered to be used in a wide variety of industrial and commercial applications where chemicals and fluid waste must be contained and/or captured and removed from the site.

The Vacu-Boom is a hollow, flexible tube five inches in diameter that is placed directly on a hard surface to form a downslope side dam or to completely encircle the wash or containment area. The boom has a C shaped cross section with the open side down. There are small liquid inlet openings on the water side of the boom at the bottom edge. During use, the boom is connected by a 25 ft. vacuum hose to the portable wet vacuum recovery unit.

These units are usually built to order, so delivery may take two weeks or so.



Check out VacuBoom prices at our NEW store! CLICK HERE NOW!
Vacu-Boom System Vb5-Vr1A Pressure Washer Part5 ft. Vacu-Boom system with 101 CFM vacuum recovery unit, automatic pump out system, hoses and fittings for use in a sloped surface application.

Complete with:
* 5' Vacu-Boom collector section
* 25 ft. long 2" vac hose with Cam-Lever quick coupler
* Heavy duty portable wet vac, 101 CFM
* Automatic pump-out system (inside the wet vac)
* 25 ft. long 1 1/2" discharge hose with Cam-Lever quick coupler

92580
Vacu-Boom System Vb10-Vr1A Pressure Washer PartSame as above with 10' Vacu-Boom collector section.

92582
Vacu-Boom System Vb20-Vr1B Pressure Washer PartSame as above with a 202 CFM Vacuum and a 20' Vacu-Boom collector section

92584
Vacu-Boom 5' Collector Section Pressure Washer PartVacu-Boom 5' Collector Section Pressure Washer PartHard shell that sucks down to the surface to form a dam. Liquid is collected through a center slot and sucked to the vacuum.

92586
Vacu-Boom 10' Collector Section Pressure Washer PartVacu-Boom 10' Collector Section Pressure Washer Part
92588
Vacu-Boom 20' Collector Section Pressure Washer PartVacu-Boom 20' Collector Section Pressure Washer Part
92590









YSitemap

Vacu-Boom™ For Pressure Washers